Do you believe in being prepared for the unexpected? If so, you’re not alone.
After all, it’s never been more important to be able to take care of yourself or your family when things go sideways. The world is a crazy place, and there are no guarantees, so you’d be wise to not leave anything to chance. One of the most important aspects of prepping for bad times is to make sure you understand gun repair.
This article takes a look at basic AR15 DIY gun repair so that you won’t find yourself stuck in a tough spot without adequate firepower. Keep reading to get the inside scoop.
1. Magazine Problems
The magazine in an AR15 can cause serious problems. After all, this is the part of the mechanical operation of the rifle that’s designed to feed cartridges into the weapon.
When you discover the gun is experiencing a failure to feed, you can usually track the issue to the magazine.
The key to solving this problem is to eject the magazine, clear the remaining cartridges, and then reload them.
2. Brass Over Bolt
This is the type of rifle malfunction that can drive you crazy in a hurry. Brass over bolt is caused when a piece of spent brass gets lodged above the bolt.
To resolve this issue, you’ll need to eject the magazine and then move the bolt into the rear position.
Check out this AR15 full auto.
3. Failure to Fire
There are typically two main reasons why your AR15 might fail to fire. The first is defective ammunition, and the second is the firing pin failed to strike the primer hard enough to trigger the round.
Your best course of action is to clear the round, load a fresh round, and attempt the shot again.
4. Failure to Eject
Once the round has fired, the rifle should eject the spent brass. When the brass fails to eject, either the brass is jammed partway in the chamber or has jammed into the upper part of the chamber where the bolt comes forward.
You’ll need to clear the jam and take the time to clean the rifle just in case a piece of debris has fallen inside.
5. Double-Feed
The double-feed occurs when the bolt attempts to load two rounds at once. You’ll need to pull the bolt back and lock it in the open position. Now you can drop the magazine and rack the bolt two or three times until you’re able to free the jammed rounds.
6. Stovepipe Jam
The stovepipe jam is a simple malfunction that occurs when one end of a piece of spent brass becomes jammed in the chamber. To resolve the issue, simply pull the bolt back and tip the gun so that the empty brass falls out.
Preppers Tips for Guide to Basic AR15 DIY Gun Repair
Preparing for the unexpected takes discipline and hard work. Fortunately, these tips for common gun repair problems will help you be ready to spring into action when things take a turn for the worse.
Keep reading for more valuable lifestyle tips and advice.